Stand out with this incredible ASR Exhaust Flap Control with Remote Controller RX1 for your Ferrari. (Years: 2000 - Present)

Flap control RX1 for Ferrari vehicles with vacuum system and two switching valves (type U1-2)

Ferrari California
Ferrari GTC 4 Lusso
Ferrari F355
Ferrari F360
Ferrari F430
Ferrari 458
Ferrari 488
Ferrari 488 Pista
Ferrari 550
Ferrari 575
Ferrari 599
Ferrari 612
Ferrari 812
Ferrari FF
Ferrari F12

With this control unit you have the possibility to switch your exhaust flaps manually. It is controlled using a hand-held transmitter. By default, the last mode is saved and restored when the vehicle starts.

Advantages compared to competing products

Control independent of Drive Select
- You decide on the vehicle sound and not the inserted driving profile
Correct series mode (module deactivated) even after vehicle start
- Important for visits to the workshop, service or TÜV.
Freely programmable start mode
- You decide yourself about the sound when the vehicle starts
No intervention in the CAN bus
- No danger to other control units
- No influence of software updates on the function of our control
Plug and play with original plugs
- No damage to the original cables, no use by electricity thieves

The device offers the following modes:

start mode

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the mode last set and restores it when the vehicle starts. If you want a specific starting mode, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired:

Last state: Press the "Sport Mode" button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

Assembly

Installation is plug & play. The device has vehicle-specific plugs that are simply plugged into the existing switching valve.

More properties

Can be retrofitted at any time without any traces
Independent system without intervention in the CAN bus
No error message

Remote control

High-quality and noble optics
brushed stainless steel front
Long range

Rely on our quality!

Branded product Made in Germany!

Hints

No approval in the StVO
For racing use only
When driving at full throttle, the flaps should not be completely closed
Installation at your own risk
If the instructions are disregarded, no liability will be assumed for any damage incurred

Electronic devices and batteries must not be disposed of with household waste. Please note our information on disposal. "Notes ElektroG / BattG"

Flap Controller

Sold out

Filters

Sold out

Sold out

Sold out